Wire your router to power supply, antennas and sensor
Wire the Industrial IoT Kit easily with the following steps. You will need a slotted screwdriver with a max. blade width of 2.5 mm.
-
Disconnect RS485 connector from the router and wire the sensor as shown.
Disconnect power supply connector from the router and wire the sensor and power supply unit as shown.
| Connector | Connection | Power supply unit | Sensor |
|---|---|---|---|
RS485 |
GND |
||
D+ |
red |
||
D- |
green |
||
V- V+ |
V- |
- |
black |
V+ |
+ |
yellow |
-
Connect your antenna depending on how you want to connect the router to the Internet.
|
|
Connect WLAN (Wi-Fi) antenna (10019797) to connector WLAN |
Connect cellular antenna (10019504) to connector LTE |
-
Connect sensor to connector RS485.
-
Connect power supply unit and sensor to the connector V- V+.
The Industrial IoT Kit is fully wired and ready for operation with this.
-
Connect power supply unit to electrical outlet.
Result checking
Wait until the upper LED (Power) lights permanently and continue with the next step.
Troubleshooting
-
Check the polarity on the power supply connector.
-
If the LED inside the sensor is not illuminated check the polarity of it’s power supply connection.
-
Check, whether the power supply unit supplies voltage when plugged into the electrical outlet.