Commissioning
Commission the IoT QuickStart Kit easily with the following steps. The only tool you will need is a slotted screwdriver with a max. blade width of 2.5 mm. The M2M SIM card is already inserted.
-
Disconnect RS485 connector from the router and wire the sensor as shown.
Disconnect power supply connector from the router and wire the sensor and power supply unit as shown.
| Connector | Connection | Power supply unit | Sensor |
|---|---|---|---|
RS485 |
GND |
||
D+ |
red |
||
D- |
green |
||
V- V+ |
V- |
- |
black |
V+ |
+ |
yellow |
-
The SIM card is already inserted; if it has been removed, insert with contacts facing forward and chamfer facing to the router into SIM 1 slot.
-
Connect cellular antenna (10019504) to connector LTE.
-
If WLAN (Wi-Fi) is to be used (not necessary for first commissioning),connect WLAN (Wi-Fi) antenna (10019797) to connector WLAN.
-
Connect sensor to connector RS485.
-
Connect power supply unit and sensor to the connector V- V+.
The IoT QuickStart Kit is fully wired and ready for operation with this.
-
Connect power supply unit to electrical outlet.
Wait until the center LED (WAN) lights permanently and continue with the next step.
| If the upper LED (Power) remains off, check wiring. If the center LED (WAN) remains off or blinks longer (the first login may typically last up to one minute, in exceptional cases longer), check whether the SIM card is inserted correctly and the correct antenna is connected to the correct connector. If this does not help, refer to our Technical Consulting under the phone number +49 941/58692-204 or via e-mail to quickstart@insys-icom.de. |
-
Open the link to the Remote Dashboard.
This is available in the information sheet with the access data under Remote Dashboard. Click on the link, enter it directly or use the QR code for opening.
Login using the specified credendtials.
You are now connected to a Dasboard via our remote maintenance service icom Connectivity Suite – VPN that is installed on your router / IoT Gateway locally as part of the icom Data Suite. It provides a comprehensive and easy to configure option for displaying live data such as measuring values or conditions. Watch the Dashboard for a few minutes and heat the sensor for example to observe how values change. The Dashboard also contains some useful links at the end, e.g. for consulting via e-mail or phone.
| The Dashboard has an update interval of 5 s by default. When finishing the test / use, please don’t forget to close the respective browser window to avoid an unnecessary waste of the SIM card’s data volume. |
You have put your IoT QuickStart Kit into operation successfully with this.